Terminal tape with secondary processing

Terminal tape with secondary processing production line is mainly used for the second stamping production of the terminal, the connector and the LED product material. The material is used to take the light control terminal and the feeder, the leveling machine and the feeder part are installed to avoid the trough. To avoid the end of the tape with the second stamping process was scratched, crushed, burns, with high efficiency, stability, reliability and so on.

Model selection: Vertical light control terminal feeder, Precision leveling machine, NC servo feeder
Terminal tape with secondary processing production line:
1.Uncoiler part: by the light control terminal receiver to replace the traditional Uncoiler for uncoiler, usually use vertical control single-disk receiver or vertical light control double disk feeder, fundamentally avoid the material uncoiler When the indentation, burns and scratches.
2.Leveling machine part: by the precision leveling machine to flatten the internal stress, while the leveling machine drum designed to avoid the slot on the material plating (or raised) part of the avoidance, to ensure that the ribbon flat, to eliminate the internal stress At the same time, make sure that there is no pressure on the tape.
3.The feeder part: by the NC servo feeder to complete the precision feeding, while the feeding machine up and down the drum are dedicated to avoid the slot on the material plating (or raised) part to avoid.