How to use the electronic flat uncoiler

How to use the electronic flat uncoiler

Electronic flat uncoiler is used for high-speed stamping terminals,mobile phone accessories and other raw materials narrow,thinner volume of the roll material uncoiling operation,the following Jinzhide on a simple introduction of the structure and use of electronic flat uncoiler.

First,the structure of the electronic flat uncoiler:
The electronic flat uncoiler adopts the way of horizontal uncoiling,the structure of the friction transmission operation,the speed control method of the speed control mode of the inverter. The electronic flat uncoiler has the characteristics of strong structure,the material can be stacked and placed,the speed can be adjusted,easy to operate and so on,can be used with any high-speed punch.

Second,the use of electronic flat uncoiler Note:
1.The standard electronic flat uncoiler maximum coil diameter 1000-1200mm (according to the need to build a wider model),the maximum roll material stacking height of 500mm,the fastest feeding speed of 30m/min.
2.The use of three-phase 380V power supply,can also be customized according to customer demand 220V power supply voltage.

Third,the Kaileide electronic flat uncoiler operating methods:
1.According to the thickness of the accumulated material and the width of the weight and adjust the weight of the wheel position.
2.The electronic tracker in the pendulum finally adjust to the homing state,check the plastic and electronic tracker is in the most concave cam,if not adjust to this bit.
3.Adjust the origin:adjust the square aluminum block,let it contact with the micro switch can be.
4.Adjust the limit:the limit on the wrong line received by the punch emergency switch,when the pendulum contact to the right of the micro switch,the punch automatically stop.
5.Increase the uncoiling speed:If you need to speed up,please control the box near the wrong send switch next to the speed of the potential adjustment switch from left to right twist can be.