Phone: +86-13405678499

Maintenance and repair of high speed roller feeder

Maintenance and repair of high speed roller feeder

High-speed roller feeder as a long-term use of equipment, to make its performance long-term stability, reduce failure rate, ensure security, prolong service life, we must carry out the necessary maintenance and maintenance.
roller feeder
Jinzhide High speed roller feeder maintenance compared with the maintenance of the punching machine is a lot simpler, mainly to do the following:
1. Before daily use, we need to inspect the fastening screws of the high speed roller feeder, such as the eccentric disc fixing seat, the lever, the body and so on, so as to prevent the phenomenon of loosening, not being firm or losing, so as to avoid causing the damage of the machine or the safety accident of personnel.
Roller feeder structure
Special attention point: eccentric disk fixed seat three screws fastening sex need special inspection, this is also the operator often like to ignore, these three screws once loose, the whole eccentric plate and connecting rod will have fallen risk, so this inspection must not be ignored.
2.The daily debugging process, in accordance with the different mold, the feeder height adjustment should pay attention to lock the installation of the fixed screws on the board;
3.Monthly maintenance, in addition to the basic screw fastening inspection, but also to the high speed roller feeder each butter mouth position to add butter, the specific filling position of the roller feeder instructions are detailed, respectively, located on the eccentric plate, cross joint and one-way device.
high speed roller feeder
Special note: The choice of lubricating butter is not fixed, but the need to choose different viscosity according to the actual temperature of the oil, the summer need to choose the viscosity of the larger butter, the winter need to use a small viscosity of butter (to prevent the butter solidification), Only true according to the temperature different choice of viscosity of butter can really play a good lubrication effect.

4.Roller feeder for a long time not to use, or winter use, the need to match the punching machine without feeding the 3-minute preheating test machine, so that the machine to get the necessary running-in and lubrication, so as to ensure the accuracy of temperature, extend the service life of the machine.


Post time: 09-13-2017