Small Uncoiler Machine uncoiling and coiling function
Small Uncoiler Machine has two functions: uncoiling and coiling.
Small Uncoiler Machine can be used for stamping before the production uncoiling the thin roll of coil material, can also be stamping in the production the coiling of waste material tape. Below Jinzhide to introduce the Small Uncoiler Machine uncoiling and coiling two uses :
First,Small Uncoiler Machine uncoiling use:
1.adjust the outer diameter of the material rack to about 20-30 mm smaller than the inner diameter of the roll to be loaded.
2.to determine the location of the middle block A-type frame, and the block on the A-type bolt on the lock.
3.and then carefully put the material hanging into the material hanging on the tile, and close to the block A-type frame.
4.with the expansion of the handle to tighten the inner diameter of the material, so that the tile close to the material diameter parts, remove the sling.
5.and then the outer block A-type rack mounted on the tile, and close to the coil, and then lock the block A-type frame on the bolt.
6.find the material head, switch to manual control, and then open the volume through the induction device to the Straighteners or feeders, and then switch to the automatic control of uncoiling on it.
Second, Small Uncoiler Machine coiling use:
1.adjust the diameter of the tile to be required to wrap the required diameter, the Small Uncoiler Machine on the same tile on the two blocks A-type frame to prevail, so that the two blocks between the A-type frame Width is greater than the material to be wrapped 5-10mm.
2.the material to be folded hook on any tile, switch to manual control, and then move forward, so that the material roll 5-6 laps.
3.the coiling material will not be released after the roll, you can switch to the automatic coiling material.
4.when the material to meet the requirements of the outer diameter, to stop the production line, the coiling material tightened, remove the outer block A-type frame hanging material.
Post time: 07-20-2017